MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
b. Join the back to the fronts
301
SSa-1
10-14
40/3
40/3
along the sides, through all plies,
with a row of stitches in line with
the upper and lower notches forming
an outlet at the side seams.
Continue to stitch the back lining
along the armhole up to the shoulder
seam using a 3/8 inch seam.
c. Notch the seam allowance around
armholes for better turning.
d. Join the back lining to the
301
SSa-1
10-14
A
A
front at the shoulder with a 3/8
inch seam. The seam shall extend
from the armhole seam to
approximately 3/8 to 1/2 inch from
the upper neck edge of the back
lining.
e. Pull fronts through the neck
Hand
8-10
C
opening. Turn under the raw top
(silk
edges of the back lining
)
approximately 3/8 inch and fell the
folded edges to the respective neck
extension of front and front facing.
2
Attach buckle.
2
Finished appearance. Buckle shall
be securely attached and properly
assembled to the left strap.
a. Assemble buckle to the left
301
SSb-2
10-14
A
A
strap by turning under the left end
of the strap through the buckle 3/4
to 7/8 inch. Secure buckle to strap
by stitching and backstitching the
end of the strap to the body of the
strap 3/8 inch from the end. Stitch
across the full width of the strap.
2
Make buttonholes.
3
Finished appearance. The
buttonholes shall be clean-cut, well
made and correctly positioned. The
stitching shall be securely caught
in the fabric.
a. Mark the left front for the
location of four buttonholes to
align with the eyelets in the right
front.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business