MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
b. Join facing-lining assemblies to
301
SSab-1
10-14
A
A
the front with a 1/4 inch seam and
with the stay tape positioned on the
inside of the front 1/8 inch from
the edge and caught in the
stitching. The line of stitching
shall extend from within 1 inch of
the ends of the neck extension,
along the front and bottom edge to
the side edge, catching the lower
edge of the lining pleat in the
stitching. The stay tape is not
required along the right front where
the eyelets are located.
1
Join facing-lining assemblies to
8
front with tapes. (cont'd)
c. Join the lining to the fronts
301
SSa-1
10-14
A
A
along the armhole with a 3/8 inch
seam. Clip or notch the seam
allowance along the armhole for
better turning.
1
Join neck.
9
a. Properly position the right and
301
SSa-1
10-14
A
A
left ends of neck extension for the
facing and fronts at center back and
join respectively with a 1/4 inch
seam.
b. Spread each seam open and press
smooth and flat with a heated
pressing iron.
c. Complete the closing of the neck
301
SSa-1
10-14
A
A
extensions of the fronts and facing
with 1/4 inch seams, catching the
ends of the neck seams in the
stitching.
d. Turn each front right side out,
through their respective shoulder,
forcing out the seams.
e. Baste along the front, bottom
Hand or
4-6
Commercial
and armhole edges.
101
White
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business