MIL-DTL-29389B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
N
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
O
6
Make adjustment straps.
(cont'd)
d. Position the seam at the center
301
SSa-1
10-14
A
A
of the strap and close the narrow
end with a seam 1/4 inch from the
raw edge.
e. Trim the corners at the narrow
end, turn strap through the open
end, completely working out the
corners and seam.
f. Press the strap smooth and flat
with a heated pressing iron or
pressing machine with the seam line
positioned in the center.
7
Make fronts.
a. Position the left and right
front interlining on the underside
of their respective vest fronts and
fuse (see 3.6.3).
b. Position facing rayon lining on
301
SSa-1
10-14
A
A
the inside of right front with front
and bottom edges even. Stitch the
two piles together 1/8 inch from
bottom and front edge.
c. Position a 1 inch wide by 6 inch
long strip of fusible material on
the upper and back edge of the
lining covering the raw edges and
fuse (see 3.6.3).
8
Seam darts at fronts.
Finished appearance. The darts
shall be properly positioned and
finished without pleats, puckers or
gathers.
a. Fold lower front and
301
SSa-1
10-14
A
A
interlining, matching the cut edges
of the waist darts. Seam lengthwise
along the entire length of the darts
starting 3/8 inch from the cut edges
at the lower end and tapering to a
point at the upper end.
b. Spread open the cut edges of the
darts. Press darts smooth and flat
with a heated pressed iron
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business