MIL-DTL-28920C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM
STCH
/
BOB/
NO
OPERATION
TYPE
STCH
STCH/I
NDL
LPR
TYPE
N
Attach hip pocket, flaps, and
18
label. (cont'd)
l. The depth of the pockets shall
be 5-3/4 to 6-1/4 inches when
measured on the inside of pocket
from top edge of cord facing to
bottom.
m. The finished pocket opening
(after bartacking) shall not exceed
the hip pocket flap.
n. On the finished trousers, the
pocket flaps shall be 2-1/4 + 1/4
inches at center, measured from
seam to center point.
19
Attach watch pocket.
Finished appearance. The completed
watch pocket opening shall not be
stretched and the material shall
not be exposed on the outside.
a. Position the pocket on the
301
SSe-2
12-16
40/3
outside of the right front at the
(a)
pocket notches for the pocket
opening. Seam the front part of
the pocket only to the front of
trousers 3/8 inch from the top
edge, from notch to notch.
b. Extend depth of notches to the
301
SSe-2
12-16
40/3
A
seam. Turn the pocket to the
(b)
inside of the front of trousers and
edgestitch the pocket opening 1/8
inch below the top edge.
c. Securely tack the ends of the
301
SSa-1
12-16
A
A
pocket opening through front of
trousers and front and back of
pocket.
d. In the finished trousers, the
notches for the pocket opening
shall not be exposed and the edge
of the opening shall meet the lower
edge of the waistband. The pocket
opening (after backtacking) shall
be 2-7/8 + 1/8 inches and the depth
of the pocket shall be 3-3/4 + 1/4
inches.
21
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business