MIL-DTL-28920C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM
STCH
/
BOB/
NO
OPERATION
TYPE
STCH
STCH/I
NDL
LPR
TYPE
N
36
Press seams (with heated pressing
iron or pressing machine).
Finished appearance. The seams
shall finish smooth and flat
without pleats, puckers or twists.
a. Spread open the seat and crotch
seams from top of waistband to fly
notch and press smooth and flat.
Stitch right fly lining extension
37
to crotch seams.
a. Turn under raw edge of the
301
SSa-1
12-16
40/3
A
right fly lining extension and
or
(each
(silk
6-8
0
stitch by machine or hand fell to
Hand
edge)
)
each side of the crotch seam.
(silk
)
b. The right fly lining shall
extend not less than 1/2 inch
beyond the inseam in the finished
trousers.
38
Finished waistband.
Finished appearance. The waistband
shall finish smooth, even and flat
without gathers, puckers, pleats,
or other distortions either in the
waistband or the trousers at
waistband joining. On the finished
trousers, the waistband shall be
uniformly 1-3/4 + 1/8 inches wide,
the edge of the waistband shall be
4-1/2 + 1/4 inches from the top of
the back pocket flaps and the
waistband lining shall finish 2-1/2
+ 1/8 inches wide.
a. Topstitch the waistband seam
301
LSd-2
12-16
A
40/3
1/16 inch from joining seam on
(show
(silk
(silk
trousers side (not through
finished
)
)
waistband) catching waistband
seam)
lining. The stitching shall extend
to the stitching on the left (not
across) fly and to back edge of
right fly.
29
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business