MIL-DTL-28920C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM
STCH
/
BOB/
NO
OPERATION
TYPE
STCH
STCH/I
NDL
LPR
TYPE
N
Finish left fly.
31
Finished appearance. The base of
the fly shall be finished so as to
avoid twisting, pleating or
puckering. The joining seam of
left fly to front shall not be
exposed on outside of trouser.
a. Seam back edge of left fly to
301
SSa-1
12-16
A
A
front from notch to top of
(silk
(silk
waistband uniformly 1-1/2 + 1/8
)
)
inches from front edge to fly.
Finish right fly.
32
a. Turn to the inside and
301
SSe-2
12-16
40/3
A
edgestitch right fly lining front
(b)
and top edges of right fly and
(show
through the buttonhole tab 1/8 inch
finished
from edge. The lining shall not be
seams)
exposed on the outside of the
trousers.
b. Turn under the raw edge of fly
301
LSg-2
12-16
A
40/3
lining and raise stitch the fly
(b)
(silk
joining seam, catching the turned
)
under portion of lining and slide
fastener tape in the stitching.
33
Join inseam.
Finished appearance. Inseams shall
be carefully joined with notches
matching and without twists or
puckers. The seams shall start and
finish evenly and be smooth and
flat.
a. Join the inseam from the bottom
401
SSa-1
12-16
A
A
edge of the legs to the crotch with
the notches matching as indicated
by marks on the patterns, forming
an outlet tapering the seam
allowance of the back from 1-1/8
inches at the crotch to 3/8 inch at
the knee notch.
b.
Press the inseam open.
27
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business