MIL-DTL-28920C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM
STCH
/
BOB/
NO
OPERATION
TYPE
STCH
STCH/I
NDL
LPR
TYPE
N
5
Set back pocket bearer.
Finished appearance. The pocket
bearer shall be properly positioned
and securely sewn with stitching of
uniform gage and without pleats,
puckers or other distortion.
a. The back pocket bearers shall
each be a single ply of basic
material.
b. Position the bearers on the
pocket material in accordance with
notches as indicated by marks on
the pattern.
c. Fold under the lower raw edge
301
LSd-1
12-16
A
40/3
of bearers 1/4 to 3/8 inch and
or
stitch to the pocket 1/16 to 1/8
LSbj-1
inch from the folded edge. A
selvage edge need not be turned.
6
Set side pocket bearers and
facings.
Finished appearance. The pocket
bearer and facing shall be properly
positioned and securely sewn with
stitching of uniform gage and
without pleats, puckers or other
distortion.
a. The side pocket bearers and
facings shall each be a single
piece of basic material.
b. Position the bearers and facing
on the pocket material in
accordance with notches as
indicated by marks on the pattern.
c. Fold under the lower raw edge
301
LSd-1
12-16
A
40/3
of bearers and facing 1/4 to 3/8
or
inch, stitch to the pocket 1/8 inch
LSbj-1
from the folded edge and continue
stitching across the bottom raw
edge. A selvage edge need not be
turned.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business