MIL-DTL-28920C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM
STCH
/
BOB/
NO
OPERATION
TYPE
STCH
STCH/I
NDL
LPR
TYPE
N
7
Make back pocket flaps.
Finished appearance. The flaps
shall finish smooth and flat,
without twists, pleats, or puckers
and shall be uniform in shape and
size in accordance with patterns.
The lining shall not be exposed on
the outside. The edges of the
flaps shall be well forced out and
the edge stitching shall be uniform
in width. The buttonholes shall be
correctly positioned, clean-cut and
well made, and the stitching
securely caught in the basic
material.
a. Flaps for the back pockets
shall be made of one piece of basic
material and one piece of lining
material.
b. Seam the two pieces together
301
SSe-2
12-16
A
A
3/16 to 1/4 inch from the side and
(a)
or
or
bottom edges, trimming for proper
A
A
turning when necessary.
c. Turn flap, forcing out the
301
SSe-2
12-16
A
A
corners, point, and seamed edges.
(b)
(silk
(silk
Edgestitch the seamed edges
)
)
uniformly 1/16 inch from edges
working the lining back 1/16 inch
from the finished edge of the
flaps.
d. Make a vertical, eyelet-end,
Button
48 min
A
A
taper-bar type buttonhole cut 5/8
-hole
per
(silk
(silk
inch long through the center of the
)
)
flap with the edge of the eyelet
button
1/2 to 5/8 inch above the center
-hole
point. Buttonholes shall be well
(incl.
worked over gimp to fit a 22 line
tack)
button with the ends of the
button-holes securely tacked.
The purling of the buttonhole shall
be on the outside of the flaps.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business