MIL-DTL-28920C(MC)
TABLE I.
Manufacturing requirements.
SEAM
STCH
/
BOB/
NO
OPERATION
TYPE
STCH
STCH/I
NDL
LPR
TYPE
N
1
Cutting.
a. Cut the trousers in strict
accordance with the patterns
furnished by the Government.
b. Cut the material in the
direction indicated by directional
lines on the patterns. Lay fronts
and backs so that the directional
lines are in the warp direction.
The directional lines may deviate
from the warp direction by not more
than 1 inch on both fronts and
backs. Measurements shall be taken
from the top and bottom of the
directional line on patterns to the
selvage edge of the fabric and the
difference between the two
measurements shall not exceed the
tolerance specified.
c. Cut the component parts for the
trousers from one piece of the
basic material, except the
following parts may be cut from
ends but when so cut, the parts
shall harmonize with the shade of
the trousers: belt loops, left and
right flies, fly buttonhole tab,
pocket bearers and facings.
d. Cut the pockets on the straight
of the material in accordance with
patterns. Cutting of pockets in
the direction of the filling is not
permitted except when it is
essential for economical use of the
material.
e. Cut the ornamental stripes in
the warp direction. Cut the
stripes 4 inches wide for type I
trousers and 3 inches wide for type
III trousers.
Replacement of damaged parts.
2
a. Replace any part containing
damages at time of cutting, such as
holes or serious weakening defects
such as smashes, multiple floats
and slubs likely to develop into
holes.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business