MIL-DTL-28920C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM
STCH
/
BOB/
NO
OPERATION
TYPE
STCH
STCH/I
NDL
LPR
TYPE
N
a. Belt loops shall be made from a
1 inch wide strip of the basic
material and shall finish 1/2 inch
wide and shall finish 3-1/4 inches
long.
12
(cont'd)
Make belt loops.
b. Fold in the raw edges of the
406
EFh-1
10-14
A
A
strip so that they abut each other
(silk
(silk
at the center back of the finished
)
)
loop. Join the raw edges together
with a 1/4 inch gage covering
stitch. The margin of stitching
shall be uniformly 1/8 inch from
the edges of the finished loop.
- or -
c. Fold the stripping lengthwise,
turning under the raw edges and
abutting the turned under edges at
the center. Join the abutted edges
with a covering stitch.
- or -
d. Turn under one side of the
105
EFae-1
10-14
0
0
stripping; fold the stripping
lengthwise, overlapping the turned
under edge on the raw edge at the
center. Join the lapped edges with
a covering stitch.
13
Make watch pocket (style A trousers
only).
Finished appearance. The watch
pocket bearer and watch pocket
halves shall be properly positioned
and securely sewn without pleats,
puckers, or other distortions.
a. The watch pocket shall be made
of two pieces of pocketing material
and a facing consisting of one ply
of basic material
b. Position the bearer over one
301
LSd-1
12-16
A
A
ply of pocket material with the
upper edges even. Turn under the
lower edge of bearer and seam to
the pocket 1/8 inch from the folded
edge. A selvage edge need not be
turned.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business