MIL-DTL-28902C(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
16
Attach hip pocket, flaps and label.
Finished appearance. The pockets
shall finish smooth and flat
without bulkiness, bulges, or other
distortions on the outside of the
finished trousers. The stitching
shall be uniform and secure. The
pocket openings and flaps shall be
in proper alignment.
a. Position pocket flaps on the
301
LSg-2
10-14
40/3
40/3
(a)
outside of the back, in line with
the mark as indicated by pattern
and with the pocketing on the
underside. Stitch through all
plies 3/16 to 1/4 inch from the
mark.
b. Position the hip pocket
cord on
301
SSe-2
10-14
40/3
40/3
outside of trousers in line
with
(a)
the mark and stitch through
all
plies 3/16 to 1/4 inch from
the
mark.
SSe-1
10-14
A
A
c. Cut pocket opening through the
301
or
or
back and pocketing, simultaneously.
(show
finished
40/3
40/3
The opening shall not extend beyond
the ends of the flap. Turn the
seam)
cord piece through the opening and
raise stitch back, forming a 1/8 to
3/16 inch cord edge at lower edge
of pocket opening.
d. Turn under the lower raw edge
301
LSbj-1
10-14
40/3
40/3
of cord facing and seam to
(selvage
pocketing 1/16 to 1/8 inch from
)
folded edge. When cord facing is
cut on selvage, the edge need not
be turned under.
e. Turn the pocketing wrong side
301
SSae-2
10-14
40/3
40/3
out, matching notches with pocket
or
(a)
opening, and stitch sides 3/16 to
401
SSae-2
10-14
40/3
40/3
1/4 inch from raw edges. The
(a)
stitching may extend across the
bottom folded edge.
f. Turn pocketing, forcing out
301
SSae-2
10-14
40/3
40/3
corners and seamed edges. Fold and
or
(b)
stitch the pocket 1/4 to 3/8 inch
301
OSf-1
10-14
40/3
40/3
from the side edges. Continue to
stitch along the bottom edges. The
ends of the bearer and cord facing
shall be caught in the stitching.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business