MIL-DTL-28902C(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
9
Make right fly.
(cont'd)
d. In the finished trousers, the
upper end of the lining shall
extend to top of waistband over the
waistband lining, and the lining
extension piece at the lower end
shall extend not less than 1/2 inch
beyond inseam.
Assemble right and left flies.
10
Finished appearance. The flies
shall be of even length where they
join the crotch seam. The fastener
parts shall be set so that there is
no twisting or puckering when fly
is closed.
a. Position flies with notches at
301
SSa-1
12-16
A
A
lower end matching, and seam
fastener tape to back edge of right
fly, stitching 1/4 inch from edge.
Make belt loops.
11
Finished appearance. The belt
loops shall be flat without
distortions or raw edges, with
stitching of uniform gage. The
loops shall be of uniform length
and width.
a. Belt loops shall be made from a
1 inch wide strip of the basic
material and shall finish 1/2 inch
wide and 3-1/4 inches long.
A
b. Fold in the raw edges of the
406
EFh-1
10-14
A
strip so that they abut each other
(silk
(silk
)
at the center back of the finished
)
loop. Join the raw edges together
with a 1/4 inch gage covering
stitching. The margin of stitching
shall be uniformly 1/8 inch from
the edges of the finished loop.
- or -
c. Fold the stripping lengthwise,
turning under the raw edges and
abutting the turned under edges at
the center. Join the abutted edges
with a covering stitch.
- or -
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business