MIL-DTL-28902C(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
16
Attach hip pocket, flaps and label.
(cont'd)
g. Turn flap down and raise stitch
301
LSq-2
10-14
A
A
(show
or
or
through all plies 1/16 inch from
finished
40/3
40/3
joining seam, closing top of
pocket.
seams)
h. Position the combination
301
LSbj-1
10-14
40/3
40/3
identification-size-instruction
label on the top of the right
pocketing so that on the finished
trousers it will face the wearer.
No part of the label printing will
be covered by the waistband inter-
lining curtain. Stitch the label
on all four sides 1/16 to 3/32 inch
from edges. Stitching shall not be
through printing. Stitch top edge
of the combination identification-
size-instruction label to the lower
edge of the waistband lining above
the right hip pocket. The ends of
stitching need not be tacked
provided the stitching extends at
least 1/2 inch beyond each side of
the label.
SSa-1
10-14
40/3
40/3
i. Securely bartack both ends of
301
the pocket opening through all
(each
plies of material.
end)
A
j. Raise stitch the joining seam
301
10-14
A
or
or
of the lower edge of pocket opening
40/3
through back of trousers and cord
40/3
facing only. Raise stitch the back
at upper edge of pocket opening
through all plies, closing the top
of the pocket. Securely tack both
ends of pocket openings.
k. The depth of the pockets shall
be 5-3/4 to 6-1/4 inches when
measured on the inside of pocket
from top edge of cord facing to
bottom.
l. The finished pocket opening
(after bartacking) shall not exceed
the hip pocket flap.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business