MIL-DTL-28902C(MC)
3.6.1.3. Tacking and backstitching. Ends of seams and stitching
produced with stitch type 301, when not caught in other seams or
stitching, shall be backtacked not less than 1/4 inch. Thread
breaks (all stitch types) shall be secured by stitching back or
break not less than 1/2 inch. When stitch type 401 is used, ends
of seams and stitching shall be caught in other seams or
stitching, and skipped stitches and thread breaks may be repaired
using stitch type 301 backstitched not less than 1/2 inch on each
side of the skip or break.
3.6.2 Shade marking. The component parts shall be shade marked
to insure uniform shade and size throughout the garment. Any
method of shade marking may be used except:
a.
Corrosive metal fastening devices.
b.
Sew-on shade tickets.
c.
Adhesive type tickets which show discolorations or
leave traces of paper or adhesive mass on the material upon the
removal of the tickets.
TABLE I.
Manufacturing requirements.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
a. Cut the trousers in strict
accordance with the patterns
furnished by the Government.
b. Cut the material in the
direction indicated by directional
lines on the patterns. Lay fronts
and backs so that the directional
lines are in the warp direction.
c. Cut all component parts for the
trousers from one piece of the
basic material, except the
following parts may be cut from
ends but when so cut, the parts
shall harmonize with the shade of
the trousers: belt loops, left and
right flies, fly buttonhole tab,
pocket bearers and facings.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business