MIL-DTL-82189C(MC)
TABLE I. Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
15
Seam sleeve lining at forearm.
(cont'd)
a. Position the top sleeve lining
301
SSbd-1
12-16
A
A
with upper forearm edge in line
and
with the notch in the armhole edge
SSa-1
of the under sleeve lining. The
notches at the lower forearm edge
of the top and under sleeve lining
shall match. Seam the top and
under sleeve lining together, 3/8
inch from the forearm edge of top
sleeve lining, forming a tapered
outlet on the under sleeve lining.
16
Seam sleeve lining at backarm.
Finished appearance. The backarm
seam shall finish smooth and flat
without twists, gathers, puckers,
or pleats and shall start and
finish evenly.
a. Join the top and under sleeve
301
SSa-1
12-16
A
A
linings at the backarm with a 3/8
inch seam.
17
Assemble sleeve and sleeve lining.
Finished appearance. The lining
shall be seamed to the sleeve
without twists, gathers, puckers or
pleats.
a. Position the sleeve lining on
the sleeve with the upper edge of
the lining extending approximately
1 inch beyond the armhole edge of
the sleeve.
b. Tack the sleeve lining to the
301
SSa-1
6-8
A
A
forearm and backarm seam allowance,
or
respectively, of the top sleeve,
Hand
4-6
commencing at the top edge of the
wigan reinforcement piece and
extending to approximately 6 inches
from the armhole edge at backarm
and approximately 4-1/2 inches from
armhole edge at forearm.
c.
Pull sleeve through lining.
18
Fell turnup of sleeve lining.
Finished appearance. The sleeve
lining shall not be short, tight,
or twisted at bottom of sleeves.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business