MIL-DTL-82189C(MC)
TABLE I. Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
9
Seam sleeves at forearm.
Finished appearance. The forearm
seam shall finish smooth and flat
without twists, gathers, puckers,
or pleats and shall start and
finish evenly.
a. Position the top sleeve with
301
SSbd-1
12-16
A
A
upper forearm edge in line with the
and
notch in the armhole edge of under
SSa-1
sleeve. The notches in the lower
forearm edge of top and under
sleeve shall match. Seam top and
under sleeves together, 3/8 inch
from the forearm edge of top of the
sleeve, forming a tapered outlet on
the under sleeve.
b. Spread open the seam and press
flat with a heated pressing iron.
c. Mark sleeve end for turnup; and
mark the top sleeve for positioning
the ornamental sleeve patch with
the pattern marker.
10
Baste wigan reinforcement to
sleeve.
a. Position the sleeve on the
wigan reinforcement piece with the
marks and notches matching.
b. Baste the sleeve and wigan
101
piece together at the mark for the
or
bottom turnup.
Hand
c. Tack the sleeve to the
101
SSa-1
8-12
A
A
reinforcement piece along the
or
forearm seam allowance, and along
301
8-12
A
A
the backarm edges of the top and
under sleeve.
11
Make front eyelet cover.
a. Fold front eyelet cover in half
301
SSa-1
10-14
A
A
lengthwise and stitch across bottom
edge with a 1/4 inch seam.
b. Turn the cover right side out.
Press and crease the folded and
seamed edges smooth and flat with a
iron or machine.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business