MIL-DTL-82189C(MC)
TABLE I.
Manufacturing requirements.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
a. Cut coats in strict accordance
with patterns furnished by the
Government.
b. Cut all materials in the
direction of warp as indicated by
directional lines on the patterns.
c. Cut all poly/wool/wool parts
from one piece of basic material.
Cut the strips for the shoulder
loops from the basic 2-3/4 inches
long and sufficient width so they
finish 5/8 + 1/8 inch wide and 3/4
to 1 inch long.
d. Cut the body and collar
linings, the collar eyelet covers,
and the front eyelet cover from one
piece of rayon lining material.
All other rayon lining parts may be
cut from ends. When pairs of
sleeve linings are cut from ends,
the shade of the sleeve shall
match. Cut the strips for coat
hanger and lining securing straps
1-1/8 inch wide.
e. Cut polyester or polyester
blend stays for armhole, shoulder
seams and armhole shields on the
bias, 3/4 inch wide and 4 + 1/4
inches long. Cut the polyester or
polyester blend for binding the
neck edge of the coat front
interlining on the bias, 3/4 inch
wide and approximately 5 inches
long. Cut the polyester or
polyester blend for the collar
interlining on the straight in
accordance with the pattern
furnished.
f. Cut the cotton buckram and
plastic strip for interlining the
collar on the straight in
accordance with the pattern
furnished.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business