MIL-DTL-82189C(MC)
TABLE I. Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
(cont'd)
g. Cut the cotton felt for padding
the collar 1-1/4 inches wide and of
sufficient length to fold over the
ends of the interlining for each
size of collar.
h. Cut the piping material (see
3.3.10) for piping the front and
bottom edges of coats, and
ornamental back patches on the
straight. The piping shall be cut
5/8 to 3/4 inch wide for ornamental
back patches, and 1-1/8 inches wide
for the front and bottom edges of
the coat.
i. Cut the wigan for reinforcing
the bottom of sleeves on the bias
in accordance with the pattern.
j. Punch the reinforcement discs
for buttons secured to the back
patches from cloth cotton buckram.
The reinforcement disc shall be 7/8
inch diameter with a 1/8 inch
diameter hole at the center.
k. The use of drill holes is
prohibited.
2
Replacement of damaged parts.
a. At time of cutting, replace all
parts of coat containing holes;
seriously weakening defects such as
smashes, multiple floats, loose or
weakening slubs, etc., expected to
develop into holes; shade bars and
dye streaks; or unsightly slubs,
etc., affecting appearance.
b. Replace any part damaged during
the manufacturing process by needle
chews which may be expected to
develop into a hole, scissors or
knife cuts, tears, holes, mends or
burns.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business