MIL-DTL-82172D(MC)
black chemical finish, followed by a clear lacquer coating and
conform to the requirements of Figure 9.
3.3.18.1. Eyelets. The eyelets for the collar shall be brass,
rolled flange type, with the barrel scored six to eight scores.
The eyelets shall conform to MIL-E-29652, sheet 1A-BE108 and be
enameled a black shade.
3.3.19 Labels. Each coat shall have a combination instruction/
identification label and a size label as follows. The coat is
intended to be wet (dry) cleaned and the labels shall show
fastness to wet (dry) cleaning.
3.3.19.1. Combination instruction/identification label. The
combination instruction/identification label shall conform to
type V, classes 2 and 14 (combined) of DDD-L-20 except all
printing and the space between the lines of printing shall be
minimum 10 point (approximately 1/8 inch). The content and
format shall be as follows:
Collar size:
Nomenclature:
Contract number:
Wool Products Act information:
DRY CLEAN ONLY
3.3.19.2. Size label. The size label shall conform to type V,
class 2 of DDD-L-20. The label shall consist of the numerical
size designation specified in 1.2 followed by the letters S
(short), R (regular), L (large), or XL (extra large), as shown by
the following example:
40 R
3.3.20 Vinyl piping. The white vinyl cord for piping the upper
edge of the collar shall be tubular, with 7/16 inch-wide welt and
serrated edges (see 6.5).
3.3.21 Sleeve ornamentation. The sleeve ornamentation for the
class 2 coat shall conform to type III, class 2 of MIL-DTL-82194
except that the embroidery yarns used shall be tarnish resistant,
synthetic, metallic yarn conforming to MIL-E-17568. This
ornamentation shall normally be furnished by the Government and
attached during manufacturing of the coat.
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business