MIL-DTL-82172D(MC)
TABLE I.
Manufacturing requirements.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
1
Cutting.
a. Cut coats in strict accordance
with patterns furnished by the
Government.
b. Cut all materials in the
direction indicated by the
directional lines on the patterns.
c. Cut all scarlet wool parts from
one piece of basic material, except
the following parts may be cut from
ends: under ply of the shoulder
straps, and under ply of ornamental
sleeve patch. Parts cut from ends
shall harmonize with the shade of the
coat.
d. Cut the body and collar linings,
the collar eyelet covers, and the top
ply of the underarm shields from one
piece of rayon lining material. All
other rayon lining parts may be cut
from ends. When pairs of sleeve
linings are cut from ends, the shade
of the sleeve linings shall match.
Cut the strips for coat hanger and
lining securing straps 1-1/8 inches
wide.
e. Cut polyester or polyester blend
stays for armhole and shoulder seams
on the bias, 3/4 inch wide and 4 +
1/4 inches long. Cut the polyester
and cotton for binding the neck edge
of the coat front interlining on the
bias, 3/4 inch wide and approximately
5 inches long. Cut the polyester and
cotton for the collar interlining on
the straight in accordance with the
pattern furnished.
f. Cut the cotton buckram and mylar
plastic for interlining the collar on
the straight in accordance with the
pattern furnished.
g. Cut the cotton felt for padding
the collar 1-1/4 inches wide and of
sufficient length to fold over the
ends of the interlining for each size
collar.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business