MIL-DTL-82172D(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
1
Cutting.
(cont'd)
h. Cut the piping material (see
3.3.11) for piping the front and
bottom edges of coats, edges of
shoulder straps, and ornamental
sleeve patches (class 1) on the
straight. The piping shall be cut
5/8 to 3/4 inch wide for shoulder
straps and ornamental sleeve patches,
and 1 inch wide for front and bottom
edges of the coat. Cut the
applicable binding material (see
3.3.12) for the top and bottom edges
of the collar interlining on the
straight, 1-1/8 inches wide.
i. Cut the wigan for reinforcing the
bottom of sleeves on the bias in
accordance with the pattern.
j. Punch the reinforcement discs for
buttons secured to the side seam from
cloth, cotton buckram. The
reinforcement disc shall be 7/8 inch
diameter with a 1/8 inch diameter
hole at the center.
2
Replacement of damaged parts.
a. At time of cutting, replace all
parts of coat containing holes;
seriously weakening defects such as
smashes, multiple floats, loose or
weakening slubs, etc., expected to
develop into holes; shade bars and
dye streaks; or unsightly slubs,
etc., affecting appearance.
b. Replace any part damaged during
the manufacturing process by needle
chews, which may be expected to
develop into holes; scissors or knife
cuts; tears; holes; mends or burns in
the material affecting appearance.
3
Shade marking.
a. Mark or ticket (see 3.6.1.4) all
component parts cut from one piece of
basic and lining materials, and pairs
of sleeve linings when cut from ends,
to insure uniform shade and size
throughout the coat.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business