MIL-DTL-82172D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
Make underarm shields.
6
(cont'd)
b. Turn the shield right side out,
working out the seamed edges
completely.
c. Press the shields smooth and flat
with heated pressing iron or pressing
machine.
Make belt loops.
7
Finished appearance. The belt loops
shall be uniform in appearance and
shall finish smooth and flat without
puckers, pleats, gathers, or other
distortions. The buttonholes shall
be clean cut, well made, well worked
over the gimp to fit a 27-line
insignia button. The gimp and thread
shall be pulled through to the
underside of the loops. The purling
of the buttonholes shall be on the
outside.
a. Fold the belt loops in half
lengthwise face to face forming two
plies.
b. Seam the two plies together along
301
SSe-2
12-16
A
A
the side and pointed edges, 3/16 inch
(a)
(silk) (silk)
from the raw edges.
c. Trim corners and point for proper
turning. Turn loops, working out the
point and seamed edges completely.
d. Edgestitch the loops uniformly
301
SSe-1
12-16
A
A
1/16 to 1/8 inch from folded and
(b)
(silk) (silk)
seamed edges.
(seamed
edge)
OSf-1
(folded
edge)
e. Make a horizontal eyelet end,
Button-
60 per
B
F
square bar type buttonhole, cut 3/4
hole
button- (silk) (silk)
inch long, in each loop midway
hole
between the back and front edges.
(not
The inside edge of the eyelet end of
incl.
the buttonhole shall finish 5/8 inch
bartack)
from pointed end of the loop.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business