MIL-DTL-82172D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
Make shoulder straps.
8
(cont'd)
f. Position the top ply on the under
ply face to face, with the outer edge
of piping and the raw edge of the
under ply even with the back notches
matching.
g. Stitch along the back, front, and
301
SSk-1
10-16
A
A
collar end, through all plies, 3/16
(a)
(silk) (silk)
inch from the inner raw edge of the
(without
piping. Trim any excess material if
cord)
necessary.
h. Turn straps, working out piped
edges completely.
i. Topstitch the straps uniformly,
301
SSk-1
12-16
A
A
3/16 inch from the folded edge of the
(b)
(silk) (silk)
piping.
(without
cord and
top
stitched)
j. Press the shoulder straps smooth
and flat with a heated pressing iron
or pressing machine.
k. Make a horizontal, eyelet end,
Button-
60 per
B
F
square-bar type buttonhole, cut 3/4
hole
button- (silk) (silk)
inch long, in each strap, midway
hole
between the back and front edges.
(not
The inside edge of the eyelet end of
incl.
the buttonhole shall finish 5/8 inch
bartack)
from the outer edge of the piping at
the collar end of the strap.
l. Securely bartack the end of the
Bartack
21 per
A
A
buttonhole, catching the ends of the
bartack (silk) (silk)
gimp and thread in the bartack. Trim
the ends of the gimp and thread.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business