MIL-DTL-82172D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH TYPE
BOB/
NO
OPERATION
TYPE
STCH/IN
NDL
LPR
9
Make ornamental sleeve patches (class
1 only).
Finished appearance. The ornamental
sleeve patch shall be uniform in
appearance and shall finish smooth
and flat without twists, gathers,
pleats, puckers, or other
distortions. The piping shall be
evenly worked out and shall extend
uniformly 1/8 inch beyond the seamed
edges of the sleeve patch. The
eyelets shall be well worked with the
purling on the outside of the sleeve
patch and shall finish with a 1/8 to
3/16 inch diameter opening.
a. The ornamental sleeve patch shall
be made of two plies of basic
material piped with a 3/4 inch wide
strip of the piping material
specified in 3.3.11.
b. Turn under one edge of the piping
301
EFa-1
12-16
A
A
5/16 inch. Stitch through all plies,
1/16 inch from the turned raw edge.
c. Position the right side of the
top ply of the sleeve patch on the
hemmed piping, with the raw edges of
the sleeve patch in line with the
piping stitching line.
d. Join the sleeve patch to the
301
SSe-2
12-16
A
A
piping along the top, bottom and
(a)
(silk) (silk)
scalloped edge 1/8 inch from the
inner edge of the piping.
e. Trim and notch the outer edge of
piping along the scalloped edge in
order to prevent pulling and bulges
on the edges.
f. Position the top ply of the
sleeve patch on the under ply, face
to face, with the outer edge of the
piping and the raw edge of the under
ply even.
g. Stitch along the top, bottom, and
301
SSk-1
12-16
A
A
scalloped edge, through all plies
(a)
(silk) (silk)
3/16 inch from the inner raw edge of
(without
the piping. Trim any excess material
cord)
if necessary.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business