MIL-DTL-82172D(MC)
3.3.22 Bias binding. The binding for the underarm shields shall
be bias cut of the lining material specified in 3.3.3. The
binding shall be 5/8 to 7/8 inch wide and have sized edges.
3.4. Design. The coat shall be the U.S. Marine Corps design
shown on Figures 1 through 9: a five-button, single breasted,
form-fitting, fully lined coat, having a one-piece front with
gold braid; waist and chest darts; a four-piece back without a
center vent; belt loop to button; ornamented sleeve ends;
shoulder straps to button; and a standup collar with hooks and
eyes for front closure and with a metal eyelet at each end for a
removable branch of service insignia. The collar shall have gold
lace sewn to the top, lower and ends of the outer edges of the
collar as shown in Figures 1, 2, 7 and 8. The front and bottom
edges of the coat; the top, bottom and scalloped back edges of
the ornamental sleeve patches; and the edges of the shoulder
straps shall be piped with the material specified in 3.3.11.
3.5. Patterns. Standard patterns will be furnished to the
contractor by the Government. The standard patterns shall not be
altered in any way and shall be used only as a guide for cutting
the contractor's working patterns. The contractor's working
patterns shall be identical to the standard pattern. The
standard patterns shall provide a 5/8 inch allowance for center
back, 3/4 inch allowance for side seams; and 3/8 inch allowance
for all other seams, except as otherwise specified in Table I.
Standard patterns show size and are marked and notched for proper
cutting, placement, and assembly of component parts.
3.5.1 List of pattern parts. Coats shall be cut from the
materials specified herein in accordance with the pattern parts
indicated below:
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business