MIL-DTL-82149C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
14 Stitch and press dart in under sleeve
linings. (cont'd)
b. Turn the cut edges of the dart
toward the forearm edge and press the
entire dart smooth and flat with a
heated pressing iron.
15 Seam sleeve lining at forearm.
Finished appearance. The forearm
seam shall finish smooth and flat
without twists, gathers, puckers or
pleats and shall start and finish
evenly.
a. Position the top sleeve lining
301
SSbd-1
12-16
A
A
with upper forearm edge in line with
to
the notch in the armhole edge of
SSa-1
under sleeve lining and with the
notches in lower forearm edge of top
and under sleeve linings matching.
Seam the top and under sleeve lining
together 3/8 inch from the forearm
edge of top sleeve lining, forming a
tapered outlet on the under sleeve
lining.
16 Seam sleeve lining at backarm.
Finished appearance. The backarm
seam shall finish smooth and flat
without twists, gathers, puckers or
pleats and shall start and finish
evenly.
a. Join the top and under sleeve
301
SSa-1
12-16
A
A
linings at the backarm with a 3/8
inch seam.
17 Assemble sleeve and sleeve lining.
Finished appearance. The lining
shall be seamed to the sleeve without
twists, gathers, puckers or pleats.
a. Position the sleeve lining on the
sleeve with the upper edge of the
lining extending approximately 1 inch
beyond the armhole edge of the
sleeve.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business