MIL-DTL-82149C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
11 Seam sleeve at backarm.
(cont'd)
a. Join the top and under sleeves
301
SSa-1
12-16
A
A
together at the backarm with a 3/8
(silk)
(silk)
inch seam, catching the ends of the
cuff in the seam.
b. Spread open the sleeve and cuff
seams and press smooth and flat with
a heated pressing iron.
12 Insert insignia buttons.
a. Mark each cuff for location of
three insignia buttons in accordance
with button marker.
b. Punch a hole through cuff and
sleeve at each mark for attaching of
insignia buttons.
c. Insert the shanks of the 27-line
insignia buttons through the punched
holes and attach ring toggles in each
button shank.
13 Baste and tack cuff to sleeve.
a. Turn the bottom of the cuff to
301
the inside against the bottom edge of
or
sleeve in accordance with notches,
Hand
and baste along the turned edge of
the cuff.
b. Tack the raw edge of cuffs to the
301
EFe-1
4-6
A
A
body of the sleeves with blind
(b)
stitching. The blind stitching shall
not be exposed on, or caught to, the
outside of the cuff.
14 Stitch and press dart in under sleeve
linings.
a. Fold the under sleeve lining,
301
SSa-1
12-16
A
A
matching the cut edges of the under
(cut
sleeve dart. Stitch the entire
edges)
length of the dart 1/4 inch from the
OSf-1
cut edges at the armhole and taper
(folded
the line of stitching to zero at the
edge)
lower folded edge.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business