MIL-DTL-82149C(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
(cont'd)
i. Cut the piping material (see
3.3.5) for piping the front and
bottom edges of coat, edges of
collar, top edge of ornamental sleeve
cuffs and the seam joining the skirt
to the center back on the straight.
The piping shall be cut 5/8 to 3/4
inch wide for collar and ornamental
sleeve cuffs and 1 inch wide for
fronts and bottom edges of coat and
seam joining the skirt to the center
back.
j. Punch the reinforcement discs for
buttons secured to the skirt back
seam from cloth, cotton, buckram.
The reinforcement discs shall have a
1/8 inch diameter hole at the center.
Replacement of damaged parts.
2
a. Replace at time of cutting all
parts of coat containing holes or
seriously weakening defects, such as
smashes, multiple floats, loose or
weakening slubs, etc., expected to
develop into holes, shade bars and
dye streaks or unsightly slubs, etc.,
affecting appearance.
b. Replace any part damaged during
the manufacturing process by needle
chews which may be expected to
develop into holes, scissor or knife
cuts, tears, mends or burns in the
material affecting appearance.
3
Shade marking.
a. Mark or ticket (see 3.6.1.3) all
component parts cut from one piece of
basic lining materials, and pairs of
sleeve linings when cut from ends, to
ensure uniform shade and size
throughout the coat.
b. The use of tickets with any metal
fastening devices is prohibited on
the rayon lining.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business