MIL-DTL-82193C(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
Baste wigan reinforcement to sleeve.
8
a. Position the wigan on the sleeves
with the notches on the ends of the
wigan in line with the turn-up
notches on the sleeve.
b. Tack sleeves to the reinforcement
101
4-6
A
piece along the forearm seam
or
allowance of the top of under sleeve.
Hand
or
301
8-12
A
A
c. Baste sleeve and reinforcement
101
4-6
A
piece together at the mark for the
or
bottom turn-up. Trim the ends of
Hand
wigan even with backarm edges of top
and under sleeve.
9
Seam sleeve at backarm.
Finished appearance. The backarm
seam shall finish smooth and flat
without twists, gathers, puckers, or
pleats and shall start and finish
evenly.
a. Join the top sleeve to
the under
301
SSbd-1
10-14
A
A
sleeve at the backarm with
a 3/8 inch
to
seam, catching the ends of
the wigan
SSa-1
reinforcement piece in the
stitching.
b. Spread open the seam and press
smooth and flat with a heated
pressing iron.
10 Tack sleeve turn-up to reinforcement.
a. Turn up the bottom edge of the
103
A
sleeve at the mark and tack the raw
or
edge to wigan reinforcement piece
301
EFc-1
4-6
A
A
with blind stitching. The basic
(b)
material shall not be caught in the
blind stitching. The finished bottom
turn-up shall be 2 ± 1/4 inches.
11 Seam sleeve linings.
Finished appearance. The pairs of
sleeves shall match in shade. The
seams shall start and finish evenly
at the seam.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business