MIL-DTL-82168C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
14 Attach braid to sleeve (see Figure
5).
Finished appearance. The design
formed by the braid and lace shall be
symmetrical, and firmly and uniformly
attached. The lower stripe on the
sleeves shall be from the gold lace
specified in 3.3.15.2.
a. Baste the braid and lace to the
Hand
sleeve following the markings and
flow indicated.
b. Stitch the braid and lace to the
301
SSa-1
12-16
A
A
sleeve. Stitches shall be 1/16 inch
(silk)
(silk)
from each edge, and shall not cross
the braid strands. Stitching points
1 to 6 (see Figure 5) are optional
and the directional arrows may be
reversed. The braid may be stitched
without basting, provided the
requirements are met.
15 Seam sleeves at backarm.
Finished appearance. The backarm
seam shall finish smooth and flat,
without distortions, and shall start
and finish evenly.
a. Join the top and under sleeve
301
SSa-1
12-16
A
A
together at the backarm with a 3/8
inch seam, catching the ends of the
wigan reinforcement piece and the
braid in the stitching.
b. Spread open the seam and press
smooth and flat with a heated
pressing iron.
16 Tack sleeve turnup to reinforcement.
a. Turn up the bottom edge of the
Hand
sleeve and baste.
or
101
b. Tack the raw edge of the turned
301
EFc-1
4-6
A
A
under portion to the reinforcement
or
(b)
wigan piece with blind stitching.
Hand
4-6
or
103
EFc-1
4-6
A
(b)
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business