MIL-DTL-82168C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
8
Stitch gold lace to collar and pipe
upper edge. (cont'd)
d. Position the eyelet cover on the
301
SSa-1
10-14
A
A
underside at each end of the collar,
(silk)
with one edge of the cover 3/4 to 7/8
inch from the front end, and the
bottom raw edge of the cover 1/2 to
5/8 inch from the upper cord edge.
Stitch collar to cover along the cord
edge adjacent to the stitching line
of the collar.
e. Lap the upper cord edge of collar
301
SSa-1
10-14
A
A
over the top raw edge of collar
(silk)
(silk)
lining approximately 1/2 inch from
the lining face up. Stitch collar to
lining and eyelet cover along the
cord edge adjacent to the stitching
line of the collar. The stitching
shall extend not less than 1/2 inch
from end of collar.
f. Turn the collar lining and eyelet
cover at the seam to the inside of
collar and press smooth and flat with
a heated pressing iron or pressing
machine.
9
Stitch lining to collar.
Finished appearance. Stitches
attaching the lining to the collar
shall be uniform and a minimum of
1/16 inch from the edge of the
collar.
a. Lap the upper edge of the collar
301
SSa-1
12-16
A
A
over the top raw edge of the collar
(silk)
(silk)
lining, approximately 1/2 inch, with
the lining facing up. Stitch the
collar to the lining and eyelet cover
along the upper edge adjacent to the
stitching line of the collar braid.
The stitching shall extend from
center to center of the eyelet
covers.
b. Turn collar lining and eyelet
covers at the seam to the inside of
the collar. Press smooth and flat
with a heated pressing iron or
pressing machine.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business