MIL-DTL-82168C(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
2
Replacement of damaged parts.
a. At the time of cutting, replace
any part of the coat containing
holes; seriously weakening defects
such as smashes, multiple floats,
loose or weakening slubs, etc.
expected to develop into holes, shade
bars, and dye streaks; or unsightly
slubs, etc., affecting appearance.
b. Replace any part damaged during
the manufacturing process by needle
chews which may be expected to
develop into a hole, scissors or
knife cuts, tears, holes, mends or
burns in the material affecting
appearance.
Shade marking.
3
a. Mark or ticket all component
parts (see 3.6.1.3) cut from one
piece of the wool material. Mark or
ticket all component parts cut from
one piece of rayon lining material
and the pairs of sleeve linings when
cut from ends.
b. The use of tickets with any metal
fastening devises is prohibited on
the rayon lining.
4
Make coat hanger and lining securing
straps.
Finished appearance. The coat hanger
and lining securing straps shall
finish 1/4 to 3/8 inch wide.
a. Fold the 1-1/8 inch wide strip of
301
EFp-1
12-16
A
A
lining material in half lengthwise.
Turn the edges to the inside and seam
1/16 inch from the turned edges.
b. Cut the coat hanger 3-3/4 + 1/4
inches long.
c. Cut the lining securing straps
4-1/2 + 1/4 inches long.
5
Make collar eyelet covers.
Finished appearance. The collar
eyelet covers shall finish 1-3/4 +
1/8 inches wide.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business