MIL-DTL-82163D(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
Make hip pocket flaps (style A).
6
(cont'd)
a. Flaps shall be made of two
plies of basic material, or one ply
of lining may be used as the under
ply.
b. Seam the two pieces together
301
SSe-2
12-16
A/3
A/3
3/16 to 1/4 inch from the side and
(a)
bottom edges, trimming for proper
turning when necessary.
c. Turn flap,
forcing out the
301
SSe-2
12-16
A/3
A/3
corners, point
and seamed edges.
(b)
Edgestitch the
seamed edges
(shows
uniformly 1/16
to 3/32 inch from
finished
edges.
seam)
d. Make a vertical, eyelet end,
Button-
48 min
A/3
A/3
taper-bar type buttonhole, cut 5/8
hole
per
inch long, through the center of
button-
the flap with the edge of the
hole
eyelet 1/2 to 5/8 inch above the
(incl.
center point. Buttonholes shall be
tack)
well worked over gimp to fit a
22-line button, with the ends of
the buttonholes securely tacked.
The purling of the buttonhole shall
be on the outside of the flaps.
7
Make belt loops.
Finished appearance. The belt
loops shall be flat without
distortion or raw edges. Stitching
shall be of uniform gage. The
loops shall be of uniform length
and width.
a. The seven belt loops shall be
made from a 1 inch wide strip of
the basic material and shall finish
1/2 inch wide and 3-1/4 inches
long.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business