MIL-DTL-29451B(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
g. Cut the opening for the pocket
midway between the two rows of
stitches joining the pocket and
pocket stay to the lining and facing,
tongue notching each end of the
opening.
h. Turn the pocket through the
301
BSp-2
10-14
A
A
opening to the inside with the front
and the back of the pocket toward the
bottom and top edges, respectively,
of the lining. Form the piping at
the top and bottom edge of the
opening. Topstitch the upper and
lower edges of the pocket opening
adjacent to the seamed outer edge of
the piping.
-or-
i. Accomplish the pocket opening
101
A
A
with a double piped pocket machine
or
A
A
which stitches, cuts and turns in one
301
operation. When this machine is
used, the piping piece may be trimmed
to permit insertion into the machine.
The joining seam of the top and
bottom piped edges shall be raise
stitched through lining and coat
facing prior to pocket closing and
top edge stitched through all plies.
Tack ends of pocket opening.
j. Turn down the back part of the
301
SSa-1
10-14
A
A
pocket and seam the front and back
together approximately 1/2 inch from
raw side and bottom edges, catching
the tongue notch at each end of the
tongue notch. Continue to stitch
across top of pocket adjacent to top
piping seam, catching twill stay in
stitching and closing top of pocket.
14 Assemble inside pocket on lining and
facing. (cont'd)
k. Stitch the lining, on the
301
SSv-1
10-14
A
A
outside, to the diagonal extension of
the pocket stay from the armhole end
of the pocket opening to the armhole.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business