MIL-DTL-21083E(MC)
5/ Belt length measurement shall be taken along the center from
end to end.
TABLE III.
Pocket and flap measurements. 1/
Upper pockets and flaps
Size
(Short, Regular, Long, X-Long)
36-38
40-42
44-46
(inches) (inches) (inches)
2-7/8
2-7/8
Length of flap at center point.
2-7/8
2-1/8
2-1/8
Length of flap at sides.
2-1/8
Width of flap at top edge.
6
5-1/2
5
Width of pocket at top edge,
5-3/4
5-1/4
4-3/4
side edge to side edge.
Width of pocket at bottom edge,
6-1/8
5-1/8
5-5/8
side edge to side edge.
Length of pocket, top edge to
6-1/2
6-1/2
6-1/2
bottom edge.
Lower pockets and flaps
Size
(Short, Regular, Long, X-Long)
36-38
40-42
44-46
(inches) (inches) (inches)
Length of flap at center point.
3-3/4
3-3/4
3-3/4
Length of flap at sides.
2-1/4
2-1/4
2-1/4
Width of flap at top edge.
7-3/4
8-1/4
8-3/4
Width of pocket at top edge,
7-1/2
8
8-1/2
side edge to side edge.
10
10-1/2
11
Width of pocket at bottom edge,
side edge to side edge.
Length of pocket top to bottom
edge:
10-1/2
10-1/2
10-1/2
Short
Regular
10-3/4
10-3/4
10-3/4
Long
11
11
11
Extra Long
11-3/4
11-3/4
11-3/4
1/ Tolerance on all measurements + 1/8 inch.
3.8. Workmanship. The finished coats shall conform to the
quality and grade of product established by this specification.
77
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business