MIL-DTL-82161C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
Join inseam.
25
Finished appearance. Inseams shall
be carefully joined with notches
matching and without twists or
puckers. The seams shall start and
finish evenly and be smooth and
flat.
a. Join the inseam from the bottom
401
SSa-1
12-16
A
A
edge of the legs to the crotch with
the notches matching as indicated
by marks on the patterns, forming
an outlet tapering the seam
allowance of the back from 1-1/8
inches at the crotch to 3/8 inch at
the knee notch.
b.
Press the inseam open.
26
Join crotch and seat seam.
Finished appearance. The crotch
and seat seams shall be joined with
proper tension, resulting in
sufficient elasticity of seam to
counteract strain encountered in
sitting or stooping. In the
joining of the seat seam, the
inseams shall meet.
a. Measure waist to proper size
before joining crotch, seat, and
waist seam.
b. Place the left and right
assemblies together with the edges
of the crotch seam aligned with the
waistband on the left assembly,
aligned with the waistband on the
right assembly at the fly opening,
and with the notches at the lower
end of the flies matching.
c. Join the left and right
401
SSa-2
10-14
A
A
assemblies at the crotch and seat
seam from the fly notch to a point
1/2 to 3/4 inch from the top of the
finished waistband with two rows of
stitches not more than 1/32 inch
apart, forming a 1/2 inch V-shaped
opening at back. The left and
right assemblies shall be joined at
the crotch with a 1/2 inch seam.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business