MIL-DTL-82161C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
9
Make watch pockets and attach
label. (cont'd)
b. Position the bearer over one
301
LSd-1
12-16
A
A
ply of pocket material with the
upper edges even. Turn under the
lower edge of bearer and seam to
the pocket 1/8 inch from the folded
edge. A selvage edge need not be
turned.
c. Stitch label to outside of the
301
SSa-1
12-16
40/3
40/3
front half of one watch pocket on
all four sides. Position of label
on finished trousers shall be
centered, 1/2 inch below the
finished pocket opening.
d. Properly position front and
301
SSe-2
12-16
40/3
40/3
back pieces of the pocket with
(a)
edges even and join together at the
side and bottom edges with a 1/4
inch seam. The stitching shall
extend from notch to notch at upper
side edges.
e. Turn the pocket, forcing out
301
SSe-2
12-16
40/3
40/3
the seamed edges. Topstitch the
(b)
pocket uniformly 1/4 inch from the
seamed edges.
10
Make waistband lining.
Finished appearance. The waistband
lining shall be without distortion.
a. The waistband lining shall be
made of one ply of lining material
and one ply of buckram.
b. Overlap lining material on
301
LSa-1
6-10
40/3
40/3
buckram 3/4 inch and stitch 1/8 to
or
3/16 inch from edge of lining
401
material. Fold lining material
over buckram and press.
- or -
c. Use a commercial, buckram
interlined, waistband lining,
provided the furnished lining
conforms to specification
requirements.
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business