MIL-DTL-82161C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
21
Join lining to waistband.
(cont'd)
b. Left end of waistband lining
shall finish at front edge of
trousers, with the end of the
waist- band lining trimmed slightly
back from front edge on an angle.
Right end of waistband lining shall
extend approximately one inch under
the fly lining in the finished
trouser.
22
Press waistband.
a. Turn out front end of left and
right waistband, forcing out the
corners. Turn waistband lining to
inside the press along the top edge
of waistband. Trouser waistband
lining shall not be exposed beyond
top edge of waistband.
b. Finished width of waistband
shall be 1-3/4 + 1/8 inches.
23
Finish left fly.
Finished appearance. The base of
the fly should be finished so as to
avoid twisting, pleating or
puckering. The joining seam of
left fly to front shall not be
exposed on outside of trouser.
a. Seam back edge of left fly to
301
SSa-1
12-16
A
A
front from notch to top of
(silk
waistband uniformly 1-1/2 + 1/8
)
inches from front edge to fly.
24
Finish right fly.
a. Turn to the inside and
301
SSe-2
12-16
40/3
A
edgestitch right fly lining front
(b)
and top edges of right fly and
(show
through the buttonhole tab 1/8 inch
finished
from edge.
seams)
The lining shall not be exposed on
the outside of the trousers.
b. Turn under the raw edge of fly
301
LSg-2
12-16
A
40/3
lining and raise stitch the fly
(b)
(silk
joining seam, catching the turned
)
under portion of lining and slide
fastener tape in the stitching.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business