MIL-DTL-82161C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
Attach watch pockets.
13
(cont'd)
b. Extend depth of notches to the
301
SSe-2
12-16
40/3
A
seam. Turn the pocket to the
(b)
inside of the front of trousers and
edgestitch the pocket opening 1/8
inch below the top edge.
c. Securely tack the ends of the
301
SSa-1
12-16
A
A
pocket opening through front of
trousers and front and back of
pocket.
d. In the finished trousers, the
notches for the pocket opening
shall not be exposed and the edge
of the opening shall meet the lower
edge of the waistband. The pocket
opening (after bartacking) shall be
2-7/8 + 1/8 inches and the depth of
the pocket shall be 3-3/4 + 1/4
inches.
14
Join fly assembly to fronts.
Finished appearance. The seam
joining the fly assembly to the
front shall be without pleats,
puckers, twists, or other
distortions.
a. Sew on left fly with 3/8 inch
301
SSa-1
12-16
A
A
seam with notches matching.
b. Turn left fly to the inside
with joining seam 1/8 inch back of
folded edge and press front edge
without damage to the fastener.
c. Sew on right fly with 3/8 inch
301
LSq-2
12-16
A
A
seam with notches matching.
(a)
d. Press right fly seam open and
flat with heated pressing iron with
the fastener tape facing towards
side seam.
Join outseams.
15
Finished appearance. Outseams
shall be carefully joined, with
notches matching, and without
twists, puckers, or pleats. The
seams shall start and finish evenly
and lie smooth and flat.
15
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business