MIL-DTL-82161C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
Make right fly.
7
(cont'd)
a. The fly shall consist of one
ply of basic material, a buttonhole
tab and the lining.
b. Position the buttonhole tab on
the outside of the fly, with raw
edges even and the upper finished
edge of tab in line with the notch
in the upper front edge of fly.
c. Seam fly and lining together
301
SSe-2
12-16
40/3
40/3
3/16 inch from front edge. The
(a)
or
or
seam shall extend from the bottom
A
A
edge of fly up to the upper edge of
buttonhole tab, catching the tab in
the stitching.
d. In the finished trousers, the
upper end of the lining shall
extend to top of waistband over the
waistband lining, and the lining
extension piece at the lower end
shall extend not less than 1/2 inch
beyond inseam.
8
Assemble right and left flies.
Finished appearance. The flies
shall be of even length where they
join the crotch seam. The fastener
parts shall be set so that there is
no twisting or puckering when fly
is closed.
a. Position flies with notches at
301
SSa-1
12-16
A
A
lower end matching, and seam
fastener tape to back edge of right
fly, stitching 1/4 inch from edge.
9
Make watch pockets and attach
label.
Finished appearance. The watch
pocket bearer and watch pocket
halves shall be properly positioned
and securely sewn without pleats,
puckers, or other distortions.
a. The watch pocket shall be made
of two pieces of pocketing material
and a facing consisting of one ply
of basic material.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business