MIL-DTL-82161C(MC)
Manufacturing requirements - Continued.
TABLE I.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/I
NDL
LPR
N
5
(cont'd)
Make left fly.
a. Position slide fastener on fly
301
LSbj-2
12-16
A
A
and interlining material with
or
401
bottom end of chain 1/4 to 1/2 inch
above the fly notch. The front
edge of chain shall be 5/8 to 3/4
inch from front edge of finished
fly at top, tapering from 3/8 to
1/2 inch at the bottom. Seam
fastener tape to fly through the
interlining with a double row of
stitches 3/16 to 1/4 inch gage.
b. Overedge the back edge of left
503
SSa-1
6-10
70/2
70/2
fly and fly interlining together.
or
504
Make buttonhole tab for right fly.
6
Finished appearance. The
buttonhole table shall finish
without distortion, with the
buttonhole stitching securely
caught in the fabric and with the
seams finished at the edge of the
tab.
a. The tab shall be made of two
plies of basic material.
b. Seam the plies together at top,
301
SSe-2
12-16
A
A
front and bottom edges with 3/16 to
(a)
1/4 inch seam and turn, forming out
all edges.
c. Topstitch the tab 1/16 to 1/8
301
SSe-2
12-16
A
A
inch from the seamed edges.
(b)
d. Make a 5/8 inch long,
Button
48 min
A
A
horizontal, eyelet-end, taper-bar
- hole
per
(silk
type buttonhole through the center
)
of tab with edge of eyelet 1/2 +
button
1/8 inch from finished end of tab.
-hole
The buttonhole shall be well worked
(incl.
over gimp to fit a 22 line button
tack)
and with the purling on inner side
of tab.
7
Make right fly.
Finished appearance. The right fly
shall finish without bulkiness,
twists, puckers, or pleats.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business