MIL-DTL-28936B(MC)
TABLE I.
Manufacturing requirements.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
1
Cutting.
a. Cut vest in strict accordance
with patterns furnished.
b. Cut all materials in the
direction indicated by the
directional lines on the patterns.
c. Cut all component parts of the
vest from one piece of material
except the eyelet reinforcement
pieces and pocket stays may be cut
from ends.
d. Cut the elastic webbing 24
inches long.
e. Cut the velcro fastening tape
4-1/2 to 5 inches long.
f. The use of drill holes is
prohibited.
2
Replacement of damaged parts.
a. Replace at time of cutting any
part damaged, such as holes, or
seriously weakening defects such as
smashes, multiple floats, and slubs
likely to develop into holes.
b. Replace any part damaged during
the manufacturing process by needle
chews, which may develop into a
hole, scissors or knife cuts,
tears, holes, mends or burns.
3
Shade marking.
a. Mark or ticket component parts
cut from basic material in order to
ensure proper assembly and a
uniform shade throughout.
b. Adhesive tickets, when used
shall be adhered to the inside.
4
Make welt.
Finished appearance. The welt
shall be uniformly made and
stitched, and shall finish smooth
and flat without twists, puckers or
pleats.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business