MIL-DTL-28936B(MC)
TABLE I.
Manufacturing requirements - Continued.
SEAM/
STCH
STCH
BOB/
NO
OPERATION
TYPE
TYPE
STCH/IN
NDL
LPR
7
Dress left front and left facing.
a. Dress left front and left
facing the full length of the
eyelet stand as indicated by the
mark on the pattern. This
operation may be performed in the
cutting operation.
8
Stitch bridle tape to lapel.
Finished appearance. The bridle
tape shall be stitched along the
breakline with the proper tensions
to allow the lapel to roll properly
in the finished vest.
a. Position the 1/4 inch wide
bridle tape on the underside of the
fronts along the breakline of lapel
and with the front edge of the tape
in line with the breakline. The
tape shall extend from the gorge to
approximately 1 inch above the
lower edge of lapel.
b. Stitch the tape through the
301
SSau-2
12-16
40
40
front of the vest evenly, smoothly
and with normal tension, holding
the tape taut and working in 1/2 to
5/8 inch of fullness along the
breakline. The tape shall be
stitched 1/16 inch from each edge.
9
Make eyelet opening.
a. Position the eyelet opening
301
SSe-2
12-16
40
40
bearer on the outside of the right
(a)
front facing in accordance with the
marks on the pattern. Stitch
lining piece to facing from upper
to lower marks with two rows of
stitching 3/8 inch apart. Cut an
opening through the lining and
facing between the stitch lines,
tongue notching both ends.
b. Turn lining to the inside of
301
SSe-2
12-16
40
40
the facing and edge stitch 1/16 to
(b)
1/8 inch from the seamed edge.
Tack each end of eyelet opening.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business