A-A-52112B
Patterns. The Government shall furnish a single size pattern. The contractor is responsible for grading patterns for additional sizes. The patterns provide for a seam allowance of 1/4 inch for joining seams except 3/8 inch for setting the pen and breast pockets, collar setting, and seaming. The government patterns shall be used to make the contractor’s working patterns. The government patterns shall not be altered in any way. The working patterns may be modified to accommodate automation; however, if the working patterns are modified, the design and measurements must be maintained as intended by government patterns.
Sizes and Measurements. The finished Types I and II shirt shall conform to the measurements below.
Table I. Finished measurements (in inches).
|
Shirt size |
Neck size 1/ |
1/2 Chest 2/ |
Back length 3/ |
Collar opening 4/ |
|
13 |
13-1/2 |
18-1/2 |
30-1/4 |
5/8 to 7/8 inch (applicable to all sizes) |
|
13-1/2 |
14 |
19-1/2 |
30-1/2 |
|
|
14 |
14-1/2 |
20-1/2 |
30-3/4 |
|
|
14-1/2 |
15 |
21-1/2 |
31 |
|
|
15 |
15-1/2 |
22-1/2 |
31-1/4 |
|
|
15-1/2 |
16 |
23-1/2 |
31-1/2 |
|
|
16 |
16-1/2 |
24-1/2 |
31-3/4 |
|
|
16-1/2 |
17 |
25-1/2 |
32 |
|
|
17 |
17-1/2 |
26-1/2 |
32-1/4 |
|
|
17-1/2 |
18 |
27-1/2 |
32-1/2 |
|
|
18 |
18-1/2 |
28-1/2 |
32-3/4 |
|
|
Tolerance: |
||||
|
Plus: |
1/8 |
3/8 |
1/2 |
|
|
Minus: |
1/8 |
3/8 |
1/4 |
|
1/ Neck measurement shall be taken from center of button to front cut end of buttonhole, with collar in flat position.
2/ Chest measurement shall be taken from folded edge to folded edge at base of armhole with shirt buttoned (see A of Figures 1 and 2).
3/ Back length measurement shall be taken at center back from collar setting seam to bottom edge of shirt (see B of Figures 1 and 2).
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business