A-A-52112 Shirt, Man's

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14

A-A-52112B

Pocket and pocket flaps. The pocket flaps shall have one buttonhole. It shall be centered and 3/8 to 1/2 inch from bottom edge of flap. The flap shall be edge-stitched 3/16 to 1/4 inch from edges, and the tops of flat corners shall be tacked. The pocket depth at center for all sizes shall finish 5-7/8 (± 3/16) with a 1-1/4 inch wide pleat (+ 1/16, -1/8 inch tolerance) for all sizes. The pockets and flaps shall be in parallel alignment with each other and the front edge of shirt. The ends of pocket openings shall be covered by the flap. The distance between the top of pocket and the top folded flap edge on the finished shirt shall be 3/4 (± 1/8) inch. The pocket shall be sewn on the fronts 1/16 to 1/8 inch from the edge with stitching continuing 1/4 to 3/8 inch across the top of pockets and 1/2 to 5/8 inch diagonally down to the line of pocket stitching.

Sleeves. The type II shirt sleeves shall have a 1 (± 1/8) inch wide hem. The type I and II shirt bottoms shall have a 1/8 to 5/16 inch wide hem.

Material. The basic material shall be 65 ± 5% polyester, with the remaining percentage cotton. The material shall be plain weave broadcloth threaded with a durable press finish, shade Army Green 415, and shall meet the following requirements:

Fusible interlining. The fusible interlining used for the collar, collarstand, shoulder straps and cuffs, where applicable, shall be a nonwoven thermal bonded substrate containing a minimum of 50% polyester with the remaining fiber being nylon. The adhesive shall be either polyester or polyethylene, depending on the type of soil release finish applied to the shirting material.