MIL-DTL-43335G
STITCHES
THREAD
SEAM
PER
BOBBIN/
STITCH
AND
INCH
NEEDLE
No.
MANUFACTURING OPERATION
TYPE
STITCH
LOOPER
REQUIREMENTS
TYPE
4.
Bind edges:
The binding shall finish 1 ± 1/8
inches wide and the end of
binding shall turned under in the
stitching.
b. Splicing shall be accomplished 301 OR LSd-1
10-12 or
B
B
by stitching aross the entire width 1/2
28 per
of the binding 1/16 to 3/16 inches INCH
tack
from edge and shall be through all BARTACK
superimposed plies of binding.
Not more than two plies of the
binding shall be permitted per
liner.
Note: The beginning and end of
the binding shall be considered
one splice and shall be stitched
across the entire width of the
binding.
5.
Tie laces.
a. Eight tie laces shall be
positioned on the Binding with
one located in each corner and
one on each side equidistant from
the corners and 1/8 ± 1/16 inch
from the inside edge of the
binding (as shown on figures 1, 2,
or 3).
The bartack shall be through the
binding.
b. Fold tie laces in half and
Bartack
28 per
B
B
bartack across folded end to liner:
bartack
spread laces so that inside edges
are abutted and bartack across the
width of both laces and bartack
laces as indicated in figures 1, 2
and 3.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business