MIL-DTL-43335G
ASNI/ASQC Z1.4 - Sampling Procedures and Tables for Inspection by
Attributes
(Copies may be obtained from the American Society for Quality Control, P.O. Box 3005,
611 E. Wisconsin Avenue, Milwaukee, WI 53201-4606.)
(Non-Government standards and other publications are normally available from the
organizations that prepare or distribute the documents. These documents also may be available in
or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection
in accordance with 4.3.
3.2 Guide samples. Samples, when furnished, are solely for guidance and information to the
contractor (see 6.4). Variation from this specification may appear in the sample, in which case
this specification shall govern.
3.3 Materials. It is encouraged that recycled material be used when practical as long as it meets
the requirements of this specification.
3.3.1 Batting. The quilted polyester batting shall conform to type VIII, cover C (for class 1) or
cover E (for class 2), style a, class 6 of MIL-B-41826 except that the outer covering for batting
intended for liners made according to figure 1 may be full width, or may be joined with a single
seam (before quilting) as specified in 3.3.1.1 to achieve the full width or length required for
liners. The bonded batting intended for liners made according to figure 1 shall be full width and
length and butting or lapping is not permitted in either direction.
3.3.1.1 Seaming of cover material (for liners made according to figure 1). The nylon rip-stop
material shall be joined before quilting, using seam type Ssa-l and stitch type 301 conforming to
ASTM-D-6193. The seam allowance shall be not less than 1/2 inch and the number of stitches
shall be 10 to 12 per inch. The thread for seaming of cover material shall be nylon, type I. class
A or B, size B of V-T-295. The thread shall be dyed Camouflage Green 483 (for class 1) or
Khaki P-1, C.A. 66019 (for class 2) and shall show fastness to laundering as specified for nylon
thread in MIL-B-41826.
3.3.2 Binding. The cloth used for binding all sides of the liner shall be 3 ounce nylon oxford
cloth dyed a good match to the ground shade of the base material, conforming to type I, class 2
of MIL-C-508, except that the test for wet-drycleaning, shall not apply.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business