MIL-DTL-43335G
4.4.4 End item dimensional examination. The end items shall be examined for the defects listed
below. The lot size shall be expressed in units of one liner. The sample size shall be one liner.
The inspection level shall be S-3 and the AQL, expressed in terms of defects per hundred units,
shall be 1.5.
Examine
Defect
Liner
Length less than 91 or more than 92 inches.
Width less than 64 1/2 or more than 1 1/8 inches wide.
Binding
Less than 7/8 or more than 1/8 inches wide.
Tie Laces
Length less than 17 1/2 or more than 18 1/2 inches.
4.4.5 Packaging Examination. The fully packaged end items shall be examined for the defects
listed below. The lot size shall be expressed in units of shipping containers. The sample unit
shall be one shipping container fully packaged. The inspection level shall be S-2 and the AQL,
expressed in terms of defects per hundred units shall be 1.5.
Examine
Defects
Markings (exterior
Omitted; incorrect; illegible; of improper size, location
and interior)
sequence, or method of application.
Materials
Any component missing, damaged, or not as specified.
Workmanship
Inadequate application of components, such as:
incomplete sealing or closure of container flap, improper taping,
loose strapping, or inadequate stapling.
Bulged or distorted container.
Content
Number of bundles per shipping container is more or
less than required.
Number of liners per bundle is more or less than required.
5. Packaging.
5.1 Preservation. Each liner shall be laid out flat and folded in half the length and in half the
width. The liner shall again be folded in half the length and in half the width, with the label
visible and facing up. Ten liners reversed end for end shall be neatly stacked in a bundle and
securely tied.
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business