MIL-DTL-28902C(MC)
3/ Twice the measurement across trousers, one inch above fly
bartack, from folded edge to folded edge.
4/ The location of knee measurements shall be 12-1/2 inches below
the crotch seam for X-Shorts, 13-1/2 inches for Shorts,
14-1/2 inches for Regulars, 15-1/2 inches for Longs and
16-1/2 inches for X-Longs.
5/ Measure along (unhemmed) bottom edge of leg from folded edge
to folded edge.
6/ Measure along inseam from crotch seam to unhemmed bottom edge.
(An allowance of three inches for hems is included in the
inseam length.)
3.8. Workmanship. The finished trousers shall conform to the
quality and grade of product established by this specification.
3.9. Recycled, recovered, or environmentally preferable
materials. Recycled, recovered, or environmentally preferable
materials should be used to the maximum extent possible provided
that the material meets or exceeds the operational and
maintenance requirements, and promotes economically advantageous
life cycle costs.
4.
VERIFICATION
4.1. Classification of inspection. The inspection requirements
specified herein are classified as follows:
a.
First article inspection (see 4.3).
b.
Conformance inspection (see 4.4).
4.2. Inspection conditions. Unless otherwise specified, all
inspections shall be performed in accordance with the test
conditions specified in MIL-STD-1488.
4.3. First article inspection. When first article is required,
inspection shall be made of completely fabricated trousers for
all provisions of this specification.
4.4. Conformance inspection. Inspection shall be performed in
accordance with MIL-STD-1488.
29
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business