A-A-55095A
3.1.3 Waistband. The waistband shall finish 1-3/4 (+1/8) inches wide and shall be centered over
upper and lower body seam. The waistband shall be edge stitched 1/16 inch from upper and lower
edge.
3.1.4 Cuffs. The cuff of the sleeves shall have square ends and a two button adjustment on the sleeve
tab (see figure 1). The buttons shall be positioned on each sleeve cuff with the first button ¾ (+1/8) inch
from the finished square edge of the cuff and the second button 1-1/4 (+1/8) inches from the first button
when measured from center to center of the button. The finished cuff shall measure 1-3/4 inches in
length.
3.1.5 Sleeve placket. The sleeve shall have a lapped sleeve placket opening, measuring 5-1/4 (+1/4)
inches.
3.1.6 Bottom hem. The finished bottom leg hems shall measure 5/8 (+1/8).
3.1.7 Bartacks The coveralls' bartacks shall be located in the following areas for reinforcement:
horizontal bar tack on top folded ends of slide fastener tape through front; horizontal bartacks at top
corners of both hip pockets; horizontal or vertical bartack at lower corner of lower front pocket
openings; horizontal bartack at upper corner of lower front pocket openings (see figure 4), horizontal
bartack across seam allowance at top of sleeve opening; vertical bartack superimposed on inner row of
stitching on bottom corner of all pocket flaps; vertical bartacks according to marks on pattern for pencil
pocket opening; horizontal bartack on "J" stitching at top of crotch seam through all plies of slide
fastener tape and left and right fronts of coveralls.
3.1.8 Figure. The figures 1, 2, 3, 4, 5, and 6 are furnished for information purposes only. When
inconsistencies exist between the written description and the figure, the written description shall govern.
3.2 Material
3.2.1 Basic material. The basic material shall be a 2 up, 1 down, right or left hand twill that contains
65% + 5% polyester fiber and not less than 30% cotton based on the dry weight of the desized
specimens when tested as specified in Table I. The color of the cloth shall be shade Blue 3329 for the
Class 1 coverall and Green 3454 for the Class 2 coverall. The yarns shall be a blend of polyester and
cotton drawn and evenly spun into singles yarn for both the warp and filling. The cloth shall be singed,
desized, scoured, dyed, heat set and treated to provide a supple hand and durable crease-resistant
finish equal to the standard sample. The use of sulfur dyes or dyes containing elementary sulfur or sulfur
compounds capable of oxidation to sulfuric acid is prohibited. The material shall meet the following
requirements:
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business